I've tried cleaning the front camera at a stoplight, no can do!
The only time I can spray the front camera is while I'm Park. Kinda useless that way since I can manually get out and spray with a spray bottle at that time.
I wonder if there's a way to calibrate the windshield washer pump in the software?
Since everything is run by control modules, and software controls the control modules actions, at some point I have to be able to control the amount of washer fluid that comes out through the software.
As much as I hate to say it, this problem may be caused by a Software Update. My wipers worked just fine and sprayed wonderfully up until I brought it in for a service appointment and they replaced the control module up in the frunk area. The control module wouldn't have had anything to do with...
Could Winter washer fluid just have a thicker viscosity fluid than Summer washer fluid, and the washer fluid pump is just that sensitive?
I think I will probably use "My wife's toothbrush" ? to clean all the holes on the wiper arm to see if that helps.
If that didn't do the trick, then I may...
I had a problem just like that when I was on vacation, and Tesla worked on it for almost a week, and ended up replacing a power conversion system, somewhere up behind the Frunk. I haven't had any problems since but it has only been about a thousand miles so far.
Tesla Replaced the "Power Conversion System", is what what was written on my invoice. It's been a week since picking up my Cybertruck from Service, and No issues since.
Do you know what parts they had to replace?
Mine is in right now and I'm on Vacation 14hr drive from home.
My CT is a dual motor, 22k VIN, sounds like the same issues as yours has.
I don't know for sure yet, but I think they are replacing 2 Control modules, I'm not sure which modules