I would install myself, Iām very handy.
These are the needed parts.
Part Number
Description
Qty
2275529-00-A
BLT, FCS, M4x8, [088], G1009
4
1008842-00-A
BOLT, PF, M6x12, [98], G1409
2
2267108-00-A
LH OFFROAD LAMP BRACKET w PAD
1
2267109-00-A
RH OFFROAD LAMP BRACKET w PAD...
Of course! Nobody going to argue that.
However, getting our hands on the bracket hardware is the issue as you know.
That said, we eventually got our hands on the light bar itself which was inconceivable a year ago, so anything is possible.
iām getting ready to do my own DIY install of an OEM light bar I picked up for my AWD. After having read this entire thread, is there anyone that still has had it on for a period of time with the tape method or has everyone chickened out? š¬
I have an OEM light bar I have not installed yet. I don't have a FS Beast, so installing on my own. If you get the brackets from Tesla, I'd be thrilled to buy them from you. Sent DM.
I have a do it yourself wrap kit I want to put on, but I noticed my rear quarter panel is slightly loose on the top, itās not terrible, but I could pull it back with my hand versus the other side. I cannot do this. Should I have service replace this before I wrap it or is this not that big of a...