From the install video as attached, I see metal shavings while being drilled from the decorative pedal being shown, but no black plastic shavings from the actual pedal mechanism. Leads to believe the pop rivet is not doing what it's suppose to be held securely. If an individual that had this...
Well if they used a blind/pop type rivet.
Hope they used a backup washer on the upset side (which is the mushroom expanded side) this allows for more surface area for securing.
See below example.
I noticed that the backup air suspension connector located behind the passenger side rear wheel had no dust/debris cap.
There's dust caps for air stem valves on tires, dust caps to refill your freon connector and dust caps for your brake cylinder bleeder valves.
Why not for the Air suspension...
First clean and wipe.
Clean again with clay bar and solution and wipe.
Do an application with citrus type solution and wipe.
Do one last clean possible alcohol/water mixture and wipe.
Bamm
Measure opening, obtain your desired sized stainless steel mesh ( i used 3/16 sized opening), remove frunk pan , remove all bumper hardware. Remove bumper fascia, Measure, and cut your mesh figure out how u want fasten in place. Reinstall . See service manual for removal and reinstall...
+ Stainless Steel Mesh inlet screen install. Prevent debris from clogging your Radiator efficiency
+ Painted Calipers, Black lug nuts, Black Center Cap.
+ Washer Fluid gasket/fluid reservior alignment. Tried loosening all bolts for frunk tray. Still Gap.
https://www.businessinsider.com/fisker-ocean-ev-price-cuts-stock-delisting-bankruptcy-2024-3
Fisker cuts $24,000 off the price of its Ocean SUV in an attempt to stay alive
Nora Naughton
Mar 27, 2024, 8:49 AM PD
Hint -- some people may want to buy up the spare parts, you can make lots of $$$$...