Recent content by panabax

Curious if anyone else has seen this behavior. Used FSD point to point and when I got to my destination, it picked a spot, pulled in head first then backed out like it was lining it up better then pulled in again then pulled out. It just kept doing it until I took over.

I have had success with the 50 kW chargers. There are 2 at the Rudy's on Hwy 9 in Norman that work for me. I was surprised when that 200 kW charger worked for me. I am headed to Norman again in a couple weeks. I will see if I can try it again. I can get to Norman with a 25% SOC, but it is a...

Update 2025.38.3.2 may have opened up these old Francis chargers for us. According to Grok, the update includes improvements related to initializing at third party chargers. I live in Dallas and frequently travel to Norman. Because my CT won't charge on the Francis Energy chargers, I have to...

There are now 4 FS CB available on the Tesla website in my area (Dallas). Each is $108k with all the incentives offered back in June except for 0% APR. It looks like the promotional rate now is 2.49%. Interestingly, they are not all optioned the same but they are all the same price, $108k...

That's pretty cool. One of the issues in the CT is that there is no available 12V source. However, the OBDII port is definitely a source for 12V power. Of course, I have no idea how much power it is rated for. I would guess not much at all, but it would probably run a radar detector or...

Here is what it looks like now with the 90 degree connector.

Yes. You can move the wire around quite a bit. That is pretty soft rubber it is going through and that is just where it ended up. Once I get the 90 degree adapter later today, I will try to clean it up a bit in there and will likely move the wire closer to the right side of the outlet so it...

"There is a principle which is a bar against all information, which is proof against all arguments, and which cannot fail to keep a man in everlasting ignorance—that principle is contempt prior to investigation." - William Paley The Cybertruck is the best driving experience of any vehicle I...

Thanks. That is exactly what I needed to see. It looks straight forward enough, with the exception of the removal of the screen plug, which will take some finesse and patients. I will give it a try tonight. I should have the 90 degree connector by then so that will complete this project.

No hole is needed. You just run the cable under the edge of the center trim on the floor back to the console and then it runs under the front panel of the center console at the corner, where the front panel, the side panel and the center trim piece meet at the floor. The cable does not interfere...

Is there a write up somewhere explaining how to remove the screen? Sounds awful but it's probably just two t20 screws. Either way, I'd love a little more detail.

I saw them popping in and out at the end of June. I'm in Dallas. I had one "in my cart" on two separate occasions but got cold feet and didn't pull the trigger and then they were gone. After that I checked the website a couple times a day and the next time one popped up I jumped on it. That's...

I purchased a 90 degree usb-c adapter so it will sit flatter against the front of the console. I think that will clean it up pretty well. However, I was not able to fully hide the cable as it makes its way down the front of the dash. I can easily get it behind the white top trim and, with a...

there's nothing on the other side. You can't see it from inside the console but if you push your finger in the triangle you can push the rubber trim under the outlet out and run your usb cable right through it. I suspect that is what it is for. I can't image any other reason to have that there.

Those orange wires feed the AC outlet in the console. If you pull the front panel off you will see the orange wires and you can find it from there. Yes, it's that little triangle. It comes out just below the AC outlet. Attached are a couple pictures from the inside of the console. I can't...