Hansshow V2 (2.5 / 3) Upgraded Media Rearview Mirror Install Article and Video

[Shygar]

Nice, did you silicone it or anything or do any extra work to it? Mine leaks exactly there where the cable passes under the trim. I've tried silicone but still no success.

No I just kind of tucked it under the glass.

Sponsored

 

[Shygar]

Nice, did you silicone it or anything or do any extra work to it? Mine leaks exactly there where the cable passes under the trim. I've tried silicone but still no success.

It weirdly rained today, so I checked again and it's still dry in my bed.

 

[That Beast Mode]

It weirdly rained today, so I checked again and it's still dry in my bed.

Kinda impossible to tell from the pics, but I believe you. You would need to check the back glass and wall as that is where it runs down, it doesnt pool in the bed normally as it just runs out down that wall. Also, mine doesnt do it unless its a decent amount of rain overall.

 

[Shygar]

Kinda impossible to tell from the pics, but I believe you. You would need to check the back glass and wall as that is where it runs down, it doesnt pool in the bed normally as it just runs out down that wall. Also, mine doesnt do it unless its a decent amount of rain overall.

It was kind of a light rain, but yea I haven't noticed it even in a touchless car wash.

 

[TeslaKen]

Kinda impossible to tell from the pics, but I believe you. You would need to check the back glass and wall as that is where it runs down, it doesnt pool in the bed normally as it just runs out down that wall. Also, mine doesnt do it unless its a decent amount of rain overall.

I will try to get some pics as well. I tucked the wire up under the glass edge with some of those plastic pry tools and then awhile back I put a new seal all along the whole metal piece to stop leaks per a video I found on YouTube. The extra seal makes a world of different in my opinion as the factory seal leaves a lot to be desired... I do NOT have the extra slat in my tonneau cover nor do I think it is needed as that will only slightly reduce any splash water that hits the tonneau cover and bounces underneath the metal overhang piece. An extra slat would only reduce that slightly which you can see if you crawl inside your bed with a light and close the tonneau cover and then inspect.

How about some pictures taken in the rain just now? Truck has been sitting outside in the rain for hours...

 

[arodriguezfeo]

Anyone here know of someone in Central Florida that will do the install?

Sponsored