Search results

I'll have my brother swing in he lives in Julian

Thanks!

We talking free ball or the entire mirror?

Thanks for the info, I sent a DM to Rodger.

I was not brave enough to drill that big of a hole. I needed one wire to go into that panel so I put a small notch up at the glass. Kind of a semicircle so it didn't pinch the wire. One drawback to the Wolfbox is all the wire connections are on the top rather than to back side.

Did you add anything to the CT mount ball end? The adapter plate I have is too large for the CT ball. I have the G900 Pro which may have a different ball receiver on the mounting plate.

Please make an adapter plate / mount for the Cybertruck. I've had the 900 pro since last year but had to install in a way that is less desirable. The ball mount on the CT mirror is to small for the Wolfbox generic Tesla adapter plate I purchased from your online store. The portion I circled...

https://www.amazon.com/uxcell-10-Ft-Management-Protector/dp/B0DFGY32SX https://www.amazon.com/MGI-SpeedWare-Split-Sleeve-High-Temperature-Automotive/dp/B09VV75KBT

Tesla calls it a water management channel.

I used 1/4" but you might be able to go down to 1/8" wire loom. I think in the resting position it's the diameter they say. The 1/4" is about 1" flattened out so 1/8 may work. They only sell 1/8 in 25' length. https://www.amazon.com/dp/B07FW5H57B

I want to put a bit of black tape to hide the frayed edges of the wire loom. I think it looks better. Forgot the temp measurement. Another day.

We'll see if this comes to market. https://gosun.co/products/ev-solar-charger-deposit

I used a non aggressive double sided carpet tape between the CT mirror and the new mirror. I'm holding out hope they make a bracket that will fit the ball end of the CT bracket. I already popped the CT mirror off so just have to get it to fit the Wolfbox mounting bracket. I'll try the wire loom...

Hoping you'll make a mount for the Cybertruck. See my previous post in this thread. The ball is to small to fit in your adapter plate.

Who is doing these polls? Skeptical of the motives...

Who is doing these polls? Skeptical of the motives...

Flashing lights, smoke and the crypt keeper...

Not any more! I had this Jack for years in the garage so I made a mount out of 1 1/2" PVC conduit and mounted to the underside of the shelf. The mount flexes a little but rests nicely on the tire. Very solid...

There could be a way but the fit is tight on the trim pieces. To get the power I tapped into two wires behind the lower area and stuffed a 12V/24V to 5V Converter in there. I notched an area up high to route the wire. This allows the trim to lay flat. I'll get a pic tomorrow...

Mine looks bad but no FSD complaints