Search results

TESLA just recently installed my light bar. They did a good job. It looks good, but I did do it myself, as I recommended the past I would use Goop. It holds like iron. It doesn’t damage the surfaces that is in contact with, if you ever decide to remove or replace the light bar, it can be done...

What you are buying is virtually a brand new cyber truck from SpaceX. SpaceX bought 1,279 Cybertrucks in Q4 2025 alone. That was about 18% of all U.S. Cybertruck registrations that quarter. Their SpaceX IPO filing shows they spent 131 million dollars on Cybertrucks in 2025, which lines up with...

NICE……..I agree a good company to deal with. Their rims even put some pep into my Beast…

With the foundation series Beast, I also have a rubber and Carpet., now I have rubber, carpet and carpet.

(y)

it’s good to hear the wisdom of an old Iron Butt rider that only comes with age……😂

DOUBLE UP…THE WENNEBIRD have built in velcro on the back so they lock onto the stock . Just take care aligning them so they leave space around the accelerator peddle. Doubling up helps to keep them in place and adds soun d proofing.

AMAZON.. they are thick and well made with Velcro on the back. If your carpet underneath doesn’t slip these won’t either. I have had no issues with their sliding up onto the gas peddle. Actually the added thickness seems to stop it from happening and they lay firmly in place Visit the Store...

Even relatively quiet tires like Michelins, noise level changes from different types of pavement. with the Cyb truck you notice a lot of tire noise on some pavements. I looked into some articles showing the removing a lot of the flooring interior of the total truck to add an asphalt, aluminum...

Realistic projection with 50% daily charging + good habits (home AC Level 2 charging, moderate temperatures, avoiding frequent Supercharging or extreme heat/cold) — 15–20+ years or 300,000–500,000+ miles before reaching ~70–80% capacity. Many owners see only 0–6% degradation in the first 1–2...

Finally got my light bar installed after 2 1/2 years. I was concerned about the brackets on the end being obtuse, but I think they look fine. They blend right in. I was also concerned about wind noise, but I haven’t noticed any. I think it looks great. Since it’s illegal to run on the roads at...

60 mph zone

I too wish FSD had a setting where you could set the upper speed with a click of a button when you’re on self driving in any mode. This is three points on my license..

What Tesla Says Happens at 0% and Why It’s a Problem • “Never allow the Battery to fully discharge. … Discharging the Battery to 0% may result in damage to vehicle components.” tesla.com • “If you allow the Battery to discharge to 0%, other components may become damaged or require replacement...

….the problem with too high a charging rate theory causing heat being involved in the failure of the PCS is that my PCS failure occurred while I was still charging overnightlwith TESLA‘s 110 V charger for 99% of my charging.

My PCS failed while I was still charging it on a 120 V charger and adding only two or 3 mph. I don’t think babying it has anything to do with failure.

I wonder if this had anything to do with my problem…..😎

When my PCS failed and stopped taking a charge on my home charger I contacted service and they said it a probably still be charged on super chargers…. It would not take a charge. They took it right in. Then after when my mid-voltage backbone harness when out, not only did the screen go crazy...

Good Article to read if you haven’t already. My PCS failed on my Beast and months later the wiring harness failed and went brick. The article says they should have both been replaced at the same time. My question is are they upgrading to what is installed in the 2026 or is this a quick...

No…..but I did just get this update, after my Beast shut down, locked up the rear axle, and was flat bedded to Tesla Service.