Search results

Last night it worked! I don't know what changed, but I didn't get this error, and now I'm signed in to Grok again from Cybertruck. ✅

Starting yesterday, I have this EXACT same error message and issue.

Sure! ? This was a pretty easy setup for me. I operated 20 meters FT8 in my usual way: - IC-705 at my usual 10 watts. The Bioenno battery was in the passenger seat. - Laptop on my lap, running my homebrew software + WSJT-X - The usual cables, toroid, RFI choke - The usual Icom AH-705 tuner -...

Seems I installed mine the wrong way. Nevertheless, it WORKED GREAT for driveways-on-the-air!

Yeah, the entire front of CT was covered up with snow & slush. Didn't know until I got off the interstate when I realized I couldn't see the road. Cybertruck's entire front-end was *packed* with frozen slush from the interstate. I couldn't remove it with my bare hands when I pulled over on a...

Heavy blowing snow and slush froze over my headlight bar last night. It was very difficult for me to see while driving. Turning on the brights had no effect. I turned on my hazards and followed the road's tire tracks *very slowly* to get home. Anyone else experience this? What's the solution?

Looking forward to seeing your work, Jack! ☑️?

I got 12 Packouts attached, been doing some road testing. So far so good.

Well now I feel stupid ? I’ll give that a shot!

PS: I couldn’t get the Putco plate mounted to the Tesla side-mounted Molle panels. I couldn’t get the Putco “nut plate” behind the Molle.

Each Putco plate is freestanding. The 3D printed spacer block has a hole for the 2” bolt to go thru.

PS: Had to buy 2” replacement bolts for the Putco bracket bolts, so the screws would extend thru the 3D printed spacer blocks.

I I was able to attach some Packouts to the Tesla Vault Divider using Putco Packout aluminum mounting brackets (via Amazon) and some custom 32mm thick 3D printed spacer blocks, which extend the Putco plate out far enough so you can mount the Packouts. I have NOT field tested this yet for...