Cutting my Vinyl Roll for Kit

[Kalease]

I brought a roll of Aura vinyl a little while back, wondering if any shops here on the forum would cut the templates (for a fee).

Looking to speed up install time vs cutting.

Sponsored

 

[TwiztOG43]

How much did you purchase? Looking to do the same.

 

[getsometom]

I was informed by a wrap company a 5ft x 75ft roll would be sufficient but I cannot verify.

 

[Kalease]

How much did you purchase? Looking to do the same.

5x75ft

 

[Kalease]

I was informed by a wrap company a 5ft x 75ft roll would be sufficient but I cannot verify.

Was told this should do it with a tiny bit left over. We will see : )

 

[Pops]

I would say just go for it and don't be afraid. I have done DIY wraps on motorcycles before, the CT should be a breeze. Yes having them precut would make it easier, but its not hard to cut, it just adds time.

I will be doing my CT wrap DIY, I just have not found a color I am in love with yet.

 

[Kalease]

I would say just go for it and don't be afraid. I have done DIY wraps on motorcycles before, the CT should be a breeze. Yes having them precut would make it easier, but its not hard to cut, it just adds time.

I will be doing my CT wrap DIY, I just have not found a color I am in love with yet.

Thanks @Pops, I’ll give it a go!

If you go with vinyl check out Aura they have the largest selection I’ve come across, 400+

Sponsored