entry mode height

[Bumn]

is there a way to make the truck stay at entry height while driving? would the truck need to be lowered with a kit to keep it at entry ride height? thanks

Sponsored

 

[ninjasplicer]

is there a way to make the truck stay at entry height while driving? would the truck need to be lowered with a kit to keep it at entry ride height? thanks

I have the cyberbeast and I think beast mode is pretty close to entry height. I’ll have to check and let you know.

 

[Swalltr]

beast mode is pretty close, but entry is lower

 

[ponch]

Any issues with always driving in Beast mode? I’ve heard the hard acceleration puts more wear on the tires but I’d assume it’s not a huge deal if I’m not heavy with the foot.

 

[Lasttoy]

I wish we could lower it more over say 70. Less air under vehicle means less drag and more range. Think S, very low on interstate

 

[ABILISK]

Any issues with always driving in Beast mode? I’ve heard the hard acceleration puts more wear on the tires but I’d assume it’s not a huge deal if I’m not heavy with the foot.

Hard acceleration does indeed wear out the tires faster. Totally worth it, but if you want to avoid that you can use the custom mode and keep it in sport mode for acceleration and at a low ride height.

 

[ninjasplicer]

I have the cyberbeast and I think beast mode is pretty close to entry height. I’ll have to check and let you know.

is there a way to make the truck stay at entry height while driving? would the truck need to be lowered with a kit to keep it at entry ride height? thanks

So I measured the entry mode height to the bottom trim underneath the door frame and it’s about 9.5” from the ground on entry mode. I have the standard 35” street tires on 20” wheels by the way. “Low” mode is about 10” so interesting only about 1/2” difference there. Put it in beast mode and the dynamics screen option says ride height set at “lower”. “Lower” is not an option on the general ride height screen, even when in beast mode. Drove it around and when I stop to get out it seems to be in “Low” at 10” clearance via measuring tape.

Sponsored