Molle Cargo Divider by Tesstudio

[CARisma]

Sponsored

 

[JackCypher]

I got the Tesla Divider right away...and now it sits in my garage...I don't use it. It could use the following design changes; in my opinion.

1. -MINUS: It *kinda* locks into the side rails...but it's not robust and once in - does not slide back-n-forth as it would seem to. Because it engages to deck floor too tightly.

2. -MINUS: It is too dependent on the bed deck level and height to lock in - in fact it did NOT fit in my CT - I had to have tesla service replace the bed deck. [That was a known issue Tesla repaired]. However if it was not for this forum I would have never known the problem was the deck bed...and not the divider. [the divide has NO adjustment Rev 01]

3. +PLUS: Once it is installed - it works good - locks in nice.

4. -MINUS: The Molle rectangle is too small for most all rachet strap hooks to hook into. It should have a few larger 'hook friendly' cutouts.

5.-MINUS: It has a nice power coat finish; which makes the fact it kinds stands up on the ground on it's own...nice as you take it out to load the bed...then it falls over, cause it *kinda* stands up..

6.-MINUS: When you are loading full bed loads - it is completely in the way, you can put it the back seat, however is has a lot of sharp corners - and that nice color passenger console touchscreen is back there to get dinged...

7. NEEDED FEATURE: It would be great in my opinion if it could panel could unlock and pivot - so you can keep it locked in, but then slide items underneath it.

8. NEEDED FEATURE: If not a pivot: then perhaps a large hole 12" x 12" where I can slide a few 2x4s thru it, so I can load lumber., bed length things without having to remove the divider.