Audio volume reset to low every time a door opened since day 1, and it won't resume after door closed. I have to turn it up every time. It's kinda annoying. My old MX will lower the volume and resume when open and close doors.
Is it just me or all like this?
---------
update: The problem was...
I installed a very slim license plate frame on the front plate holder that comes with CT. And found that it is blocking the front camera in the left lower corner.
The license plate itself is also blocking a little bit without the frame. I didn't notice that before the frame installed. The...
I had a very similar situation when picking up my new 2016 MX, a growing crack on passenger side windshield found on the second day. The crack was very smooth without any chip point, so the service center replaced the windshield under warranty.
Below is my setup, which is not working. My plate number is showing on my bill instead of the transponder number.
And this is another setup, which is also not getting any transaction.
Does anyone have a working mounting location? Thanks in advance.
Hi @loki , is you Fastrak tag working normally?
I have mine mounted vertically at the same spot but on the passenger side. My FasTrak statement is only showing my plate number, not the tag number, without multiple occupants discount, so I assume it is not working.
I noticed that most leaking in my CT bed during rain and carwash happened in one spot under the aero flap.
So I took the aero flap off, found out that the seal strip under it has a gap right at the leaking spot.
Comparing the left and right mounting locations of the aero flap, I also...
I had a membership at a automatic car wash place on my commute route, and I had washed my CT there several times. Today after finished washing my CT, I was told I can not wash it there anymore, because it is too big?‍♂️. They will cancel my membership and give a refund.
The results of automatic...
So I cleaned my CT 2 days after delivery, with Bar Keepers Friend and Windex, following the instruction from Coleton on Out of Spec Detailing. Basically, It is wet sanding the panels with BKF using the softer side of Scotch Brite, then wiping off the muddy sanding dust with Scott Shop Towels and...