Search results

I may have to use the funds from these handles to upgrade to a new printer :)

Exactly what TickTock said, 100% infill could lead to even more layer adhesion problems. I have a system going now for drying filaments after having adhesion, stringing and blob of death issues. I have this that does the "pre" drying for 48 hrs, I can have four rolls in it...

Infill gives structural integrity, it's this pattern in the inside - you can see it's more dense in the 15% vs 10%. For further reading: https://wiki.creality.com/en/software/update-released/Strength/infill

For the popcorn: here is difference in 10% vs 15%: 15%: And 10%:

Really same here - learning a lot making an actual functional part vs making little nick knacks. I didn't know about manually making seams, supports, different infill types, layer heights, speed settings, layer adhesion practices and so on. The last month has been great. @TickTock also...

With 15% infill and I manually set the seam to be at the thickest part of the handle:

Could it be due to layer height and infill? I'm printing at .20 and 15% infill and it is very strong.

Ender 3 V3 plus. I have done ABS, but it was in the summer and put the printer in my shed. It works, but really need an enclosed printer to keep the temperature constant.

If I had a multicolor printer I could do colors like you and what his design has. I just started adding little plates with multicolor that glue on.

PETG is what I've been doing and even in below freezing they look to be good. PLA version was bendy in warmer weather, not sure what it does in cold. I've been meaning to try PC, but need to vent my basement for printing in that.

Bump

Shameless plug for ordering from me - made them for 25 CTOC members already. https://www.cybertruckownersclub.com/forum/threads/emergency-pull-handles.53232/

Thanks @Jabman for the shout out - I didn't start this for the money, if this person can do it for that price, great for them. I think my price is justified for the time I'm spending. Also, I've learned a lot about printing and unfortunately fixing my printer as well. I've learned all about a...

I can certainly try - not sure on cost.

There is for sure a bit of learning/recognizing that is happening - in my driveway, the CT would just park in the middle. Then I'd disengage and park it on the right side of my driveway to line up where my charger is. After a few days of this, the CT started parking on the right side of the...

@bdesign - This is exactly what happened to my CT - would not go above 24amps. So made appointed with SC - they said most likely PCS. And a week or so later, the errors started popping up and stopped charging in the mid 70% range. Just had it changed. Here is the work that was done on mine...

Bump

Most of my communications have been through the app, the service tech have been fairly easy to chat with. Any in person chats I've had have also been pleasant and they share info readily. In my case they had the vehicle for about 5 days and gave me another CT loaner.

To those that have had this service done - have you had issues afterwards? Just wondering if this is likely to occur again, and if it's out of warranty, we would be stuck with a hefty bill.

These are emergency pull handles designed by user TickTock in this thread: https://www.cybertruckownersclub.com/forum/threads/rear-emergency-door-release-identifier-3d-print.52850/ I'm just providing the printing service as I've done for a bunch of members already. I can do red, orange, blue...