Foundation Badge Locations...

[obz]

Hey All,

I've got new foundation badges to go over my PPF, but don't know the location. Could someone take a quick distance measurement from the fender and then from the top of the fender bend? Same with the tailgate badge?

Thanks!

Sponsored

 

[MedicalMoose]

Hey All,

I've got new foundation badges to go over my PPF, but don't know the location. Could someone take a quick distance measurement from the fender and then from the top of the fender bend? Same with the tailgate badge?

Thanks!

I just looked at pictures and then put a piece of masking tape even with the front fender top, heading back, using a laser level, then put the logo material even with the tape (under tape) and made the two outer sides equal distance. Did this on both sides for front fender side logos.

Then for the tailgate, use something to hold the tailgate up at about 45 degrees or more, but not closed, for easier access to the corner where the logo goes. Then the cyberbeast logo, if applicable, is much easier to apply.

I found that using a fine point rounded tool, like a straight lock pick tool or something similar, perhaps even a toothpick, together with fine point tweezers, was easier to help separate the logo material and get it applied. I used the logo material from T Sportline.

Hope that’s helpful!