Search results

Go to service. My bed floor is warped and they are replacing it on July 1st. Said my divider will fit properly after they replace the warped bed floor.

I had mine in for service on something else yesterday. I specifically asked if I was getting a new wiper motor because of the recall and they knew nothing about it. At all. Any of them.

Took my to service center today. They said my bed was warped. Ordered a new one. And will be installing it along with a new tonneau on July 1st.

Those spots are not black, but they are from the Tire shine at your car wash.

Got mine same as everyone else, it does it fit properly in the middle third of the bed. Can’t put it exactly where you would what’s it right behind the lower storage area. I’ll try to tighten the more in the bed and see if that helps.

So I got mine. Does anybodys actually fit? Mine will fit in the front, and the back, but if I want to put it right behind where the bed opens up, it will not fit correctly.

Where did you get these hooks for the divider?

I used this on the my pontoon's tubes years and years ago.

Ok, so what’s the consensus? This stuff or DIY coating? I’ve been waiting to do mine until this question could be answered. Can it be now?

I like this one.

I bought the official cybertruck mud flaps, here's an installation video.

Made a little install video!

Made a little install video!

It’s my favorite. I’ve commented on about 10 of your videos on various platforms asking for the brand and name of the wrap Maybe I can get an answer here?

Pull them out and rotate them. Then they should stay. I got my hood perfect and they stay.

Looks like it block most of it not a bit of it.

Got Mine May 11th In Nebraska. Picked up from Council Bluffs.