The closest Superchargers are in Gila Bend, AZ. There are no Superchargers in Rocky Point, but I can charge at my house or use Level 2 chargers at resorts. The issue is I’d arrive with very little battery if I drive the Cybertruck straight there, and I’m concerned about the recent PCS issues...
At my age I need to stop and drain the lizard, before I need to charge 🤣 and walk the dog and stretch a bit.. I so much more relaxed now especially with FSD doing the heavy lifting... 95% FSD... The only truck that gets newer as it gets older
Sorry it happened - On a side note a large number of people "getting stuck" ... rather it's sand or mud. It's usually the driver's fault. By not assessing the terrain and inexperience. (EVERYONE MUST GET ONCE) Get out , access the best route to check how deep and soft it is and set the truck...
I found it annoying at first..then I changed it not to open at home. But when I want it to open - after shopping - I find it annoying in that it takes so long to open :)
It's teenage bird season when they are learning to fly and not get run over.. A Dove flew right in front of the Beast @20mph and it started to slow as the bird flew at FRUNK level left to right. It didn't slam on the brakes ... It did what a human does. School zones doing fine, firetrucks...
FYI Grok says:
This is an accurate summary of a real, widespread issue affecting many early Cybertrucks (especially 2024–early 2025 builds).
The symptoms, diagnostic codes (PCS2_a094, PCS2_a095, PCS2_a137, HV DC overcurrent trips), invasive repair process, warranty coverage details, recent...
End of July 2024: FSCB approaching 17K miles — 94% FSD. Most of the non-FSD miles are off-road mode, but I’ve used FSD on desert wash roads without any issues.
It’s the only truck that gets newer as it grows older… and it still puts a smile on my face every time.
We could really use a...
Great story and congratulations on having the gonads to do it..
How close are the nearest chargers to Moab? Did you feel like you were going onto your side? Thanks
Great job and story.... well done!