3D printable Cybertruck Food Tray

[TwiztOG43]

Printed perfect without supports.

Sponsored

 

[AverageJoe]

Now we just need a tpu mat with a cool graphic.

 

[hemiarch]

Now we just need a tpu mat with a cool graphic.

Or maybe a tiny Persian rug….super classy
https://www.etsy.com/listing/1291558100/?ref=share_ios_native_control

 

[AverageJoe]

Or maybe a tiny Persian rug….super classy
https://www.etsy.com/listing/1291558100/?ref=share_ios_native_control

Darn you and your genius ideas. I have a cart full of saved for later amazon items and the parts for the bed grab handle.

How's the handle working out?

 

[hemiarch]

They are great. I actually use the one I mounted right behind the cybertent more than the handle to step on and reach my electronic mirror camera or clean the roof glass.
Unexpected benefit.

 

[hemiarch]

Printed perfect without supports.

So which version is this exactly if I wanted to reproduce it?

 

[Sandman1962]

Printed! This is way good! Thank you! Clicks in perfectly when I remove the silicone cover I have. It fits in my glove compartment too. Thank you!! I’m inspired to make my qi chargers for the OEM charger (toaster) slots!

 

[hemiarch]

Printed! This is way good! Thank you! Clicks in perfectly when I remove the silicone cover I have. It fits in my glove compartment too. Thank you!! I’m inspired to make my qi chargers for the OEM charger (toaster) slots!

Excellent French fry holders z.

 

[drewm]

So which version is this exactly if I wanted to reproduce it?

This is the 200mm long version, so it's 30mm shorter than then one I have shipping to you. On the plus side it's super quick to remove, and I only tend to use it when I have food.

 

[TwiztOG43]

So which version is this exactly if I wanted to reproduce it?

 

[drewm]

On another random note, I'm currently printing my initial design for a rope held phone/tablet/switch holder for a rear passenger that loops around the front seat. It should fit every phone/tablet/gaming device as it has a clamping range of about 1" to 7.1"

A little ghetto with the rope, but you can always use paracord to fancy it up a bit! Hope my initial design fits together

 

[hemiarch]

Thank you. I ordered one from the OP. Will wait for it to get here and see which version it is and how it fits but I probably need this one.
Thank you OP for the killer design

 

[hemiarch]

This is the 200mm long version, so it's 30mm shorter than then one I have shipping to you. On the plus side it's super quick to remove, and I only tend to use it when I have food.

Arrived today. Thank you Drew.

 

[drewm]

A new post about the rear seat Phone/Tablet holder that I just designed and published https://www.cybertruckownersclub.co...hone-tablet-holder-for-rear-passengers.48399/

 

[Sterling Shadow]

Going to print a tray now, thanks making this and sharing.

Sponsored