Search results

Same issue. Waiting on service appt. Hope you can find the answer during your service visit.

At times you'll see errors in the service menu that never cause a fault. Try formatting your USB drive in the safety menu. Also I have a few of the same messages as you with no faults present.

They put a new mirror on and same issue so they are calling known behavior at this point.

Not for another week

Do you mind shooting me a photo of the bottom of the tonneau against the tailgate? I want to see how much the seal is pressed against the tailgate.

Thank you. I figured it probably needs adjusted but wanted to make sure it was just me.

Can someone post a picture of the top of their tonneau when closed. I have a decent gap that allows a lot of water and debris to get past the applique seal. I’ve tried calibrating and adjusting the end stops of the track but it still appears to close “too far” and a little crooked.

I have the vibration around 40-50mph with light regen. Other than that I'd say it rides very smooth.

I’ll post my service ticket but it says they verified my concern and fixed “line 1” calibrated and tested good. It has not jammed while closing again but it definitely isn’t shutting uniformly. Probably schedule it again at another point. I don’t think service is up to speed yet in cybertruck...

I don't think what he's describing is the modulated motor sound that is normal on all the cybertrucks. It's like a light rumble strip feeling in the pedal that is almost audible in light regen only around 40-50mph. I drove another cybertruck recently that didn't exhibit this behavior so I have...

Mine does the exact same thing. Only between 40-50mph approx.

Exact same situation for me. I took it in for service and they didn’t change a think. I think I tinker with mine on my own. Too me it seems like the left hand motor is behind.

Almost like the tonneau is extending too far.

I've calibrated several times and I'm getting a small gap between the top panel on the tonneau and the opplique. Anyone else's look like this? Makes a great spot for tree junk to make a new home.

Unfortunately the calibration didn't cooperate for too long. If I only partially opened the tonneau then tried to close it I was still getting into a jam. I dropped it off in Nashville this morning for a 7:45am appt to address the tonneau and a few other small issues. Unfortunately it is just...

Thought maybe this was why my tonneau was binding a few inches short of closing so I pulled the cover off this evening. The right bolt was barely tight and the completely wrong bolt. Also my seal is trashed from someone trying to jam it in when they were building the vehicle. Unfortunately my...

Did you happen to get a service appt and a remedy? Mine is scheduled in next week for a slew of other little items and this is on the list.

I have something similar. Sounds like I'm going over rumble strips between 40-50mph. Usually close to light throttle input and into regen.

Calibrate your tonneau cover. It set the end points for the open and closed position. Found in the service menu. My tonneau was binding up one side was not as far down when fully closed. This calibration helped a lot.

Def not a whine. More like someone turned on a hair trimmer if that makes sense. I'll recored a sound if I can but it's more of a feeling through the pedal.