Cybersail (Nyxon) Installed

[bdesign]

They see me ridin’ dirty:

Now I wish I’d went darker on the side window tint.
Ugh

Sponsored

 

[bdesign]

@CyberZephyr
Got the panels here www.nyxonmods.com

They’re stainless steel and powered coated - they look 100% OEM.

 

[arodriguezfeo]

How do you install these? I could not find instructions on website.

 

[Lowcoe]

Seems like a vinyl decal would do the same job. Less commitment…

 

[bdesign]

How do you install these? I could not find instructions on website.

3M tape was preapplied

It shows the back side of the panel with the tape on the products page

 

[bdesign]

Seems like a vinyl decal would do the same job. Less commitment…

it’s installed with tape, so it can be removed.
I had vinyl on mine first, but I felt it looked tacky like I was trying to fake a window.
This looks intentional

 

[arodriguezfeo]

Will the tape damage a PPF wrap?

 

[CarMan ElecTruck]

it’s installed with tape, so it can be removed.
I had vinyl on mine first, but I felt it looked tacky like I was trying to fake a window.
This looks intentional

this is still ‘faking a window’… or something

 

[bdesign]

this is still ‘faking a window’… or something

Have you installed the sticker?

Have you installed the stainless panel?

I’ve actually done both.

I guess it’s a matter of opinion, but there’s no comparison between a sticker and the stainless panel.

It may be tough to tell in a photo, but the panel looks like an actual part.

 

[bdesign]

Will the tape damage a PPF wrap?

I don’t have a wrap, and not sure if the 3M tape would damage the PPF

 

[CarMan ElecTruck]

We all know the CT does not have a window, inlet or any opening at all there therefore… ?‍

Maybe I’m just a purist

 

[bdesign]

We all know the CT does not have a window, inlet or any opening at all there therefore… ?‍

Maybe I’m just a purist

?

 

[Lowcoe]

I mean it doesn’t look horrible. I told the guy that’s making all the plastic bed surround paneling in Stainless for me (sail panels, tailgate cap etc) that people will pony up the dough for Cybertruck accessories…. Case in point.

 

[FarAway]

I am not offended by the look of the sail-panel enhancements, but the cost seems pricey for what it is....

I mean it doesn’t look horrible. I told the guy that’s making all the plastic bed surround paneling in Stainlessfor me (sail panels, tailgate cap etc) that people will pony up the dough for Cybertruck accessories….

That does seem to be the prevailing attitude.

CT owners are rich A-holes with tons of money to buy whatever and they "will pony up the dough..."

(BTW, your sail and tailgate SS panels do look nice and fulfill a practical need)

 

[arodriguezfeo]

Maybe your guy who works with steel can make a swing-out spare tire carrier an offset so that the spare does not block the rear camera, which is located towards the top and center of the tail gate.

or what about a one-piece that can hang over the tailgate and be further secured using d-rings in the bed?

Sponsored