MagBak Wireless Charger Install

[tenrten]

Unsponsored/solicited review on the MagBak Cybertruck Wireless Charger. I liked the design since it looked the "most OEM" of all the MagSafe chargers I've seen.

Installed yesterday, and I love how it looks. I hate, hate, hate wires... and other than the wire coming out of the side of the device (which is behind the screen) and the rear USB C plug in... I was able to route them all in the panels. Had to order a longer USB-C extension (4 feet). Was able to lift the front panel and route to the car's left side, run down the base and behind the floor panels. Lifted the center lip and placed under there.

Love the placement and the clean look. Would love to design a 3D Print file to hide the back wire... but that's just me being peculiar. Also need to pull open the center console panel and see if I can somehow route the USBC in there instead of the back, so it would be 99.9% wire free.

Sponsored

 

[Jes]

Mine keeps on falling off. How did you get the 3m to stick well?

 

[bigbangbadaboom]

Mine keeps on falling off. How did you get the 3m to stick well?

Contact them
I think there were a few batches where the 3m tape didn't extend all the way
I got a new one and noticed it and now its stuck there real good

Also for the wires there's a much easier way ...

no cables shown

 

[Puhiniho]

Looks great! Might I also recommend instead of routing wiring all the way back from the center/rear usbc, get a OBD to usb adapter so you can tuck/keep the wiring under the front dash (no cable extensions needed).

 

[tenrten]

Contact them
I think there were a few batches where the 3m tape didn't extend all the way
I got a new one and noticed it and now its stuck there real good

Also for the wires there's a much easier way ...

no cables shown

I tried and had a hard time running down the center… about gave up lol and then tried a new direction.

 

[tenrten]

Looks great! Might I also recommend instead of routing wiring all the way back from the center/rear usbc, get a OBD to usb adapter so you can tuck/keep the wiring under the front dash (no cable extensions needed).

This… is… brilliant.

 

[donnyb]

Looks great! Might I also recommend instead of routing wiring all the way back from the center/rear usbc, get a OBD to usb adapter so you can tuck/keep the wiring under the front dash (no cable extensions needed).

Recommended on the OBD to USB adapter. Thanks

 

[V1 R0TA8]

Recommended on the OBD to USB adapter. Thanks

Can you share a link for the adapter you purchased?

Sponsored