Partial delamination front stainless

[BabOne]

Have not seen much of this on the forum. Do not have any idea what caused this. Any others?

Sponsored

 

[EWELON]

could be the same adhesive issue that caused the cantrail recall. either way, it shouldnt be like that, obv. make a service request

 

[BabOne]

could be the same adhesive issue that caused the cantrail recall. either way, it shouldnt be like that, obv. make a service request

Going in for service and June 16. Hopefully no one gets injured with the sharp edge sticking out.

 

[Mini2nut]

Tesla switched to a new structural adhesive in 2025. It’s now blue in color.

 

[Vesder21]

I hit a deer and mine "delaminated" too

 

[EWELON]

Going in for service and June 16. Hopefully no one gets injured with the sharp edge sticking out.

could always try some double sided tape to tide you over until then. thats a good point.

 

[BabOne]

I did not hit anything and Sentry did not show anyone doing anything to the truck. Maybe the car wash had something to do with it loosening? Otherwise have no idea other than poor installation or bad adhesive.

 

[REM]

prob just bad adhesive. are you an early VIN?

 

[vandytom]

This is my concern for the rear panel. It’s already wavy during wiping

 

[BabOne]

prob just bad adhesive. are you an early VIN?

VIN is 67xxxx, manufactured January 2025

 

[SabrToothSqrl]

Blue you say.... forbidden frosting looks yummy...

 

[Black306]

Rivets: if it’s good for accelerator pedals, it’s good enough for body panels.

 

[ShockAuto]

Yes, all cybertrucks with around vin 75k and lower have the older grey glue and it can separate from the stainless, my first truck got bought back for this

 

[rtiql8n]

This is my concern for the rear panel. It’s already wavy during wiping

I had my tailgate replaced under warranty for that same wavy issue.

 

[Beetlebug62]

VIN is 67xxxx, manufactured January 2025

Interesting. Mine is 64xxx but made in Feb.

Sponsored