alex454
Active member
- Joined
- Dec 19, 2023
- Threads
- 2
- Messages
- 38
- Reaction score
- 40
- Location
- New Hill, NC
- Vehicles
- Cybertruck, Model Y
- Occupation
- Tech Executive
- Thread starter
- #1
Hello CT friends,
I had my windshield replaced on Friday due to an area of distortion. Today, the Gear Selector piece keeps falling down. I tried to snap it back in, however, it keeps falling down. Is there something special about snapping it back in place (i.e. up/down motion)>
In addition, I am getting an a "Climate keeper unavailable due to system fault" message. The HVAC will not turn on remotely; but seems to run on manual fine. Auto keeps blowing air only into the leg area. From other thread, I believe this is related to the temp/humidity sensor. I did try to reboot.
I have an appointment but their earliest availability is next month. I will try to escalate.
Any suggestions on at least getting the gear selector to snap back in place as it kind of annoying.
I had my windshield replaced on Friday due to an area of distortion. Today, the Gear Selector piece keeps falling down. I tried to snap it back in, however, it keeps falling down. Is there something special about snapping it back in place (i.e. up/down motion)>
In addition, I am getting an a "Climate keeper unavailable due to system fault" message. The HVAC will not turn on remotely; but seems to run on manual fine. Auto keeps blowing air only into the leg area. From other thread, I believe this is related to the temp/humidity sensor. I did try to reboot.
I have an appointment but their earliest availability is next month. I will try to escalate.
Any suggestions on at least getting the gear selector to snap back in place as it kind of annoying.
Sponsored
Last edited: