Factory forgot to connect two Ring Terminals?

[TCybertruck]

While installing some Lights with the Frunk Tube removed, I’ve founded these two Ring terminals unhooked on the driver side that I’ve never messed with. Does anyone know where they’re supposed to be connected to?

Sponsored

 

[dpoll995]

I’m pretty sure that’s for emergency power, if the low voltage battery dies. You can connect a jump box to those terminals so that you can pop the frunk to get to the low voltage battery. Should also let you open the doors too. Check the manual under mid voltage battery. It shows you how to get to those terminals from the fender well.

 

[TCybertruck]

I’m pretty sure that’s for emergency power, if the low voltage battery dies. You can connect a jump box to those terminals so that you can pop the frunk to get to the low voltage battery. Should also let you open the doors too. Check the manual under mid voltage battery. It shows you how to get to those terminals from the fender well.

That makes perfect sense. Thank you

 

[koolio]

I’m pretty sure that’s for emergency power, if the low voltage battery dies. You can connect a jump box to those terminals so that you can pop the frunk to get to the low voltage battery. Should also let you open the doors too. Check the manual under mid voltage battery. It shows you how to get to those terminals from the fender well.

Good call.

https://www.tesla.com/ownersmanual/... be unable to open the powered <em>frunk</em>

 

[hemiarch]

They just dangle there? Not separated from each other or isolated in any way?

 

[Crissa]

They just dangle there? Not separated from each other or isolated in any way?

They're only active when the battery is not.

-Crissa

 

[WHIZZARD OF OZ]

They just dangle there? Not separated from each other or isolated in any way?

It's the angle of the dangle that matters!

 

[hemiarch]

It's the angle of the dangle that matters!

Second only to the motion of the ocean

 

[hemiarch]

They're only active when the battery is not.

-Crissa

Makes sense.

 

[mongo]

They just dangle there? Not separated from each other or isolated in any way?

They are unpowered input connections. If the 48V system is dead, these only connect to the frunk latch actuator.

Sponsored