Question on Glossy Blank PPF Install and CT's sharp edges

[alex454]

I am getting a few estimates from installers for a Glossy Black PPF install on my Cybertruck. The first installer brought up an issue with installing the ppf on the edges near the hood and the tailgate. He denoted that the PPF will not 'wrap around' the sharp edges and a small steel line will be seen. I have a picture below. Is the installer correct that he PPF will not wrap around the small edge? Is there another solution? Is really even noticeable if not be able to wrapped over?

Attached a zoomed image with some test cuts.

Sponsored

 

[NiceCybertruck]

There have been quite a few installments with no issues. I would recommend another shop for installments. It is tough, but it can be done. If you are in California, try OC Detailing. Check out their website and YouTube. They talk about it extensively. Good luck.

 

[Noblelr3]

I saw a vendor on the Facebook site saying this same thing. He also said he wouldn’t warranty it either. He’s the only person that’s mentioned this. I would go elsewhere.

Sponsored