Tilted / lopsided rear end suspension (passenger side is 3/4" taller & higher than the driver side)

[Hims3lf]

The rear passenger side is 3/4" taller than the driver side. I have changed the height from entry to high and back again but it stays 3/4" taller. Air pressure in both rear tires are the same. The 3/4" difference stays when at its highest and lowest

Sponsored

 

[CT007]

That title really threw me off

 

[Hims3lf]

 

[Hims3lf]

That title really threw me off

One letter misplaced does make a difference

 

[Woodrick]

Is the truck level?
Could it be the normal difference to handle road camber?

 

[Nidavellir]

Try putting it in camp mode and then switch back to normal mode and see what that does

 

[Hims3lf]

Still no luck. I have a service appointment in a couple Weeks

 

[DerekCyber80s]

I have same issue now. Right rear is lower than rest of truck.

 

[Woodrick]

I have same issue now. Right rear is lower than rest of truck.

Put a level on the truck. Is it level?

 

[Hims3lf]

after months of trying to get this fixed, Tesla service says it is "within spec" and will not fix or troubleshoot the issue

 

[Hims3lf]

 

[Hims3lf]

I posted something on X about this to see if people can measure their CT's to see if they have the same issue. I have measured about 10 CT's and none have this issue.

 

[Shrey]

This sux OP. Sorry this has happened to you. Ive not heeard of this issue - Can you take it to another SC? Ive taken it to 4 different SCs over the the 6 months of owernship with varying degrees of help. Thats my suggestions.

 

[mongo]

Height should be 265mm +/-5mm (so a max difference of [Edit: 0.4 inch]) when in medium (via Toolbox, normal service mode might not get height exact enough, but you can adjust based on readout) at these points:

Procedure: https://service.tesla.com/docs/Cybe...UID-232AFE97-1156-4471-88B5-E19831F57AB1.html

 

[REM]

Measure and record while the truck is parked in the exact same spot, but oriented 180°. This will compensate for a sloping concrete pad.

Also, it may be a difference in your panel alignments. You need to measure from a common plane, like @mongo above pointed out.

Sponsored