New Update! 2024-45-25.15. FSD 13.2.4

[trentsize]

Installing my update now

Sponsored

 

[PilotMikePA]

I just got it too. So sounds like bug fixes but nothing major added?

 

[GmP]

Just downloaded and installed my update. Will see tomorrow if I notice any changes.

 

[arodriguezfeo]

Received and installed today in Central Florida.

 

[65SoYoLO]

Aaaand I got the update last night. Too cold, 10F, to go outside to check for differences, might check later.

 

[dweyant]

Just got the update and installed. Got an email that my FSD Free trial now runs until May, a month longer than before. Not complaining, but not sure why that happened.

 

[Bobo_LaDouche]

truck hugs the right side white line
hugs left in passing lane,
right in slow lane and
right on middle lane.
it makes me nervous
Anyone else experiencing the line hugging issues?

You describe my situation perfectly. FSD needs to address two main issues:
1) Stay in the lane (center!)
2) Better velocity control (follow human commands).

I am confident it will improve. My model 3 performs in an excellent manner.
(Below - drifting into oncoming traffic.)

 

[araxara]

1) Stay in the lane (center!)

Today, on FSD 13.2.4, I was driving to Phoenix on I10 (about 80mph). A section of the highway had some dust storm, but the oncomming crosswind was about 30-40mph. The Cybertruck was being pushed to the left lane and crossed the yellow line by the median.

The windbuffetting was causing the truck the vibrate too. I only had to take over one time, but it was anoying nevertheless. The rest of the time I was able to apply steeing pressure, just enough to nudge the CyberTruck into the center of the lane without disengaging.

 

[cyberHoward]

I had the same issue happen with snow coming across an open field with high-winds. The winds covered the road in places and pushed the Cybertruck to the center and beyond and then it wanted to stay on the left-hand side of the road. That has only happened once, but it really can't happen for unsupervised. I am still trying to figure out why it wants to hug the right edge lines. I did a recalibration, but I have not really seen a significant improvement. Sometimes it is near center.

Sponsored