Timed
New member
- Thread starter
- #1
Hi all, I'm trying to figure out the best way to place a powered wheelchair into the bed of the Cybertruck.
From my research and limited knowledge, it seems that an inside-bed lift should not be installed due to the electrical wiring in the bed. There are hitch mount lifts as options, but my ultimate goal is getting the chair to sit inside the bed, rather than outside in the back (which would obstruct the rear camera...).
It seems like my best option is to just have a portable ramp and drive the chair into the bed each time. However, I'm worried that the height from the ground to the tailgate would be too steep, even on entry mode.
Does anyone have any recommendations or setups that they would like to share? Thanks!
From my research and limited knowledge, it seems that an inside-bed lift should not be installed due to the electrical wiring in the bed. There are hitch mount lifts as options, but my ultimate goal is getting the chair to sit inside the bed, rather than outside in the back (which would obstruct the rear camera...).
It seems like my best option is to just have a portable ramp and drive the chair into the bed each time. However, I'm worried that the height from the ground to the tailgate would be too steep, even on entry mode.
Does anyone have any recommendations or setups that they would like to share? Thanks!
Sponsored