If you have Christmas spirit, your Cyberbeast can go to plaid mode!

[ABILISK]

1) Voice command: Turn on Santa mode
2) Get ‘er in launch mode
3) Your beast mode animation is now the plaid mode animation (with Santa’s reindeer launching his sleigh of course)

Sponsored

 

[atlbeast]

My Santa Mode…so far

 

[Dekeman]

My Santa Mode…so far

Love that! How are you affixing the lights to the steel? And where are you plugging in?

 

[ABILISK]

My Santa Mode…so far

???

 

[J.Graham]

Love that! How are you affixing the lights to the steel? And where are you plugging in?

Can we get a close-up of the clips or whatever you’re using to affix the lights? Been thinking about doing this and trying to figure out how to attach them. Thanks

 

[atlbeast]

Can we get a close-up of the clips or whatever you’re using to affix the lights? Been thinking about doing this and trying to figure out how to attach them. Thanks

3M clips on the black trim and glass. Plugged in to the outlets in the bed and closed the cover. Loving it so far.

 

[Carlos Thomas]

Christmas Spirit…

 

[LS95]

3M clips on the black trim and glass. Plugged in to the outlets in the bed and closed the cover. Loving it so far.

Something like these?

https://a.co/d/3gS1Oi9

I really want to do something like this and have been toying with the idea of tape, these, magnets, etc but each seems to come with a problem. Are you worried about a residue being left on the plastic trim?

 

[atlbeast]

Something like these?

https://a.co/d/3gS1Oi9

I really want to do something like this and have been toying with the idea of tape, these, magnets, etc but each seems to come with a problem. Are you worried about a residue being left on the plastic trim?

I was more worried about marring the ‘stainless’ steel. I think residue can come up with some alcohol on plastic surfaces without much issue, but we will see!

 

[TyPope]

I was more worried about marring the ‘stainless’ steel. I think residue can come up with some alcohol on plastic surfaces without much issue, but we will see!

Goo Gone works wonders!

 

[TeslaKen]

Playing around today and found a way to go Plaid with the Cyberbeast ??

 

[Salty_Cobalt]

Can we get a close-up of the clips or whatever you’re using to affix the lights? Been thinking about doing this and trying to figure out how to attach them. Thanks

I use the magnetic Christmas lights holders when I go to car shows... Easy to put on and off, and don't cause any damage to wraps. (link below)

https://a.co/d/biL1AtH

 

[SentinelOne]

my winter tires do not appreciate this post!

 

[getsometom]

Looks like Santa finally upgraded to the Cyberbeast.

 

[J.Graham]

I use the magnetic Christmas lights holders when I go to car shows... Easy to put on and off, and don't cause any damage to wraps. (link below)

https://a.co/d/biL1AtH

I went with Clear 3M outdoor stick on light clips. I’m 3/4 of the way through a 4000 km (2500 mile) road trip and they’ve held up perfectly!

Sponsored