3D print mount for Uniden radar detector

[salsagev]

I’m using a DLP Resin Printer.
Two attempts have broken as they can’t support the weight.
Anyone have a recommendation on a resin?

I tried multiple myself but the bottom flange is still too weak.
I just went ahead and bought this to save time.
Etsy.com/listing/1804476106/cybertruck-uniden-radar-detector-mount

Sponsored

 

[Nexus6]

I tried multiple myself but the bottom flange is still too weak.
I just went ahead and bought this to save time.
Etsy.com/listing/1804476106/cybertruck-uniden-radar-detector-mount

Thanks salsagev !
Just ordered one!

 

[Shrey]

I tried multiple myself but the bottom flange is still too weak.
I just went ahead and bought this to save time.
Etsy.com/listing/1804476106/cybertruck-uniden-radar-detector-mount

This is the one I got and its amazing! will not disappoint.

 

[pae1andonly]

I don't think it matter as the whole tonneau is not a solid metal surface. The radar signal can easy go through it. However it will block laser frequency but it doesn't matter as you are screwed when police use laser gun.

You *might not* be the target of the laser, you could be detecting splash and have some reaction time. Subject to all kinds of imponderables.

 

[deftguru]

… bought this to save time.
Etsy.com/listing/1804476106/cybertruck-uniden-radar-detector-mount

Thanks for sharing. Placed the order for the mount and a Uniden R8w. Since the R8w and tap arrived faster than etsy mount, i am currently using the suction mount that came with the unit. So far it’s holding up after a day of use. Now that I have it mounted this way, dont think i need the etsy mount anymore.

Sponsored