3D printed roof appliqué doors

[Black306]

Long story short, I needed a roof appliqué door. Since the part doesn't come up in Tesla's EPC, I think it comes only with the appliqué assembly. So, I recreated one. In case anyone needs one, here is the file....

https://www.thingiverse.com/thing:6872574

Sponsored

 

[scottf200]

I needed a roof appliqué door. Since the part doesn't come up in Tesla's EPC

Curious about your need.

EPC page (URL)

Service Manual: Exterior Trim Fittings - Roof Applique - LH (Remove and Install) (URL)

Oddly the EPC use to show both the before (with) and after (without) the doors (as of Nov 14, 2024).

Showed both sets a while back

Now (14-Dec-2024) it just show the "with rack doors"

 

[Black306]

A door went…bad. Warped for some reason.

PN on the door itself has 1848570-00-A and 1848571-00-A, neither comes up in the EPC.

 

[Black306]

This got me thinking (which can be dangerous ).... since this is 3D printed, what about a door with something some kind of novelty. For those that know about the Transformers Metroplex toy (where's my Gen X peeps?! ?), I'm thinking about the part that flips to reveal twin cannons.

What if there was an appliqué door that presents a sidewinder missile, or something.

Thoughts?

Sponsored