Does anyone have their Cybertruck connected to their powerwall and confirmed it works?

[bmek]

It sounds like you have the deployment without backup. You may be able to have it change to put some circuits behind the Gateway.

Yes, my Powerwalls were installed without backup.

I bought the CyberBeast as Tesla was including the labor so the CyberBeast could provide backup to my house when the grid goes down.

My intention is to have Tesla pay to install a gateway that will isolate my key electric loads (circuits).

Sponsored

 

[chavez2000]

I’m not doubting what they told you but I don’t think they are correct. My understanding is if you do not have Powerwall(s) you need the Powershare Gateway and the Universal Wall Connector which has the communication wire required to run to the Powershare Gateway.
My understanding is if you have Powerwall(s) installed and a Gen 3 Wall Connector you are all set. No communication wire is needed for the setup, just the software update in June or whenever it comes out. The system will work together to allow power to flow from then Cybertruck to your “home” that is behind the original Backup Gateway from the Powerwall install.

This is my understanding as well. For those of us with Powerwalls, we have to wait for software update that is not yet out for powershare

 

[walkingcrow]

Any word on that software update? I was just double checking the website and it says any generation of Tesla wall connector will work if you have a power wall.

 

[AlmostHuman]

Have not seen it here. Will be cool when it is ready!

Sponsored