Panel Gaps bother any of you?

[igs]

Because they don’t manufacture CT’s!

Neither does Fremont. ?‍

Sponsored

 

[mmdotking]

Was able to just fix them myself tonight. Well, the one on top of door that bugged me. Thankfully simple hinges.

 

[Art138]

Was able to just fix them myself tonight. Well, the one on top of door that bugged me. Thankfully simple hinges.

Luckily my truck came within close specs; poor door panel alignment would bug me; do you have wind noise or are the gaps just cosmetic?

 

[mmdotking]

Luckily my truck came within close specs; poor door panel alignment would bug me; do you have wind noise or are the gaps just cosmetic?

No wind noise. Cosmetic.

 

[togaxx]

What panel gaps?

 

[The Tumbler]

Squeaks, rattles and gaps bug me. I had the SC fix a few of each. To each is own I suppose?‍

 

[Jellybean]

Yes, they drive me crazy. SC won’t fix. They say it is in spec

 

[noobla3]

I had my driver door fixed because it was way out of spec and the tech at sc agreed. For the other panels it was not as obvious and I rather them not touch them as it can make it worse off.

 

[RAY INGRASSIA]

I cancelled my appointment to have two gaps adjusted. I got use to them. No one else ever noticed and I was afraid they'd make it worse. Hey, it's a truck not an airplane.

 

[CyberGus]

My driver's door protrudes slightly which is easily fixed by adjusting the striker. However, the door closes perfectly, and does not leak or rattle. I'm leaving it be.

 

[Willinak]

Luckily my truck came within close specs; poor door panel alignment would bug me; do you have wind noise or are the gaps just cosmetic?

VIN series?

 

[Art138]

VIN series?

27xxxxxx AUG 22/24. Only non-symmetrical panel (albeit within spec) was at the joint pictured. Not even noticeable to the casual observer.

 

[Hohenzollern]

I see Chargers / Challengers / Jeeps with massive gaps in traffic at a distance of one or two car lengths. The ones on my truck look thread-width against those.'

It is enough that mine are all uniform and reasonably narrow. I don't expect razor thin tolerance on sheet steel.

I have grudgingly driven without tunes to listen for noises...all good so far. The air suspension pump noises that was prevalent on the demo models I test drove, are not present or sufficiently reduced as to not be noticeable. Note I have it lower for egress and raise once I am back in and underway. So the suspension sees use on mine.

I do hear the fans when the battery array is being preconditioned en route to charging but I'd expect something for that.

Series VIN....xxx593xx

 

[Seksyback]

this actually looks fine to me

Sponsored