My one complaint: no place to set a drink on the roof to open the door without it falling down

[Griswold]

Love this truck but where is one supposed to temporarily place a drink on the roof to open the door without it falling down? Or toss something on the hood without it sliding off. Refresh better have roof cupholders and a hook or flat area on the hood or tonneau!!

Sponsored

 

[cattledog]

Spray bottom of cup with grip rite

 

[CyberGus]

Always park on an incline?

 

[Fugue]

https://chasmcomponents.com/products/locking-l-track-cupholder

 

[UberNoob]

I find when I place my drinks on the ground it doesn’t fall off but sometimes I get littering tickets when I drive off and forget my fresh full Starbucks.

 

[65SoYoLO]

Love this truck but where is one supposed to temporarily place a drink on the roof to open the door without it falling down? Or toss something on the hood without it sliding off. Refresh better have roof cupholders and a hook or flat area on the hood or tonneau!!

Two days late.

 

[Griswold]

Spray bottom of cup with grip rite

Ok that's a start, but too time consuming for take out beverages.

Always park on an incline?

This one is good for hilly areas.

https://chasmcomponents.com/products/locking-l-track-cupholder

But now I gotta open the tonneau?

I find when I place my drinks on the ground it doesn’t fall off but sometimes I get littering tickets when I drive off and forget my fresh full Starbucks.

Actually I never thought of the ground. I always put it on the roof of my other vehicles. This may be the solution I'm looking for, just need to remember your anecdote.

Two days late.

Haha this is legitimate, no other complaints. I overlooked the ground placement, so will try that and hope I don't kick it over or forget it.

 

[BrockN]

It's a first world problem I suffer with too...

 

[Cyberham]

I've actually wondered that too, but my to go coffee mug has a rubber bottom and is fine on an angle. And my glass mug sits fine without sliding by the Tonneau buttons but cant be to full obviously hehe

 

[dalton108]

https://chasmcomponents.com/products/locking-l-track-cupholder

Well, I’m not gonna buy that but I sure will print it if I can find the STL. Of course, at this point, you just set it on the tailgate or in the truck bed which is perfectly flat.

Also, with that said I’ve had various degrees of success with placing cups and mugs here and here! Works about as well as “sex panther.”

 

[Gaximus]

Park in high mode and put it on the tire

 

[Fugue]

Park in high mode and put it on the tire

Also doubles as a can crusher if you forget.

 

[Beyond]

Love this truck but where is one supposed to temporarily place a drink on the roof to open the door without it falling down?

Never have had to use 2 hands to open the door but if it's a problem maybe a gym membership?

 

[HaulingAss]

Love this truck but where is one supposed to temporarily place a drink on the roof to open the door without it falling down? Or toss something on the hood without it sliding off. Refresh better have roof cupholders and a hook or flat area on the hood or tonneau!!

Dang! I think you finally identified the most fatal flaw of Cybertruck's design!

There are a lot of tempting places to put a drink, but none of them are very secure unless parked on an incline. Uphill, downhill, either way works, but obviously the Californians who designed this thing had never been to Kansas!

 

[Beyond]

Dang! I think you finally identified the most fatal flaw of Cybertruck's design!

There are a lot of tempting places to put a drink, but none of them are very secure unless parked on an incline. Uphill, downhill, either way works, but obviously the Californians who designed this thing had never been to Kansas!

You have to find a highway overpass. Nebraska too.

Sponsored