FSD unavailable - "Lane Departure Avoidance features unavailable. Features may be restored on next drive."

[Sandro.natale]

Hi all,

I keep getting a message the FSD is not available due to lane departure avoidance not available. Is anyone else getting this error.

Sponsored

 

[UberNoob]

Not getting that error, but perhaps check the service mode alerts and see what’s in there.

 

[mongo]

Hi all,

I keep getting a message the FSD is not available due to lane departure avoidance not available. Is anyone else getting this error.

Check camera visibility
If that looks clear, try a DAS Reset

 

[CyberGus]

"Features may be restored on next drive"

Anyone remember when we would joke about how rebooting your PC to fix Windows was like fixing a broken-down car by everyone getting out and jumping back in?

 

[Sandro.natale]

Even more alerts now. Cameras are all clean and working fine.
No kidding CTR’s+atl+delete.
Does anyone know how to reboot the entire OS?

 

[UberNoob]

Even more alerts now. Cameras are all clean and working fine.
No kidding CTR’s+atl+delete.
Does anyone know how to reboot the entire OS?

Service mode will give you more information on those alerts. The two button solute will reboot the computer.

 

[mongo]

Even more alerts now. Cameras are all clean and working fine.
No kidding CTR’s+atl+delete.
Does anyone know how to reboot the entire OS?

Reset DAS
https://www.cybertruckownersclub.co...service-mode-quick-thanks-to-the-forum.52634/

Can also try "Power Off"

Dual scroll wheel resets MCU, not AI4.

 

[CyberGus]

For a real power-off, you can disconnect the MV battery. Requires some light disassembly.

However, I've not seen any reports of such a hard-reset resolving this issue. Instead, it's been suggested that re-calibrating the cameras could help.

After clearing the camera calibration, you won't have any Vision-AI features (FSD, blind-spot, auto turn-signal, etc.) until the re-calibration in complete. But there's good news: the fix is to take a nice long drive in your Cybertruck

 

[Moter3d]

Go cameras on the UI. Make sure all are visible. If they are, go into service mode and clear camera calibration

Sponsored