Tips on Installing Cybertruck Vault Cargo Divider

[TyPope]

Thank you for posting those measurements. Bed liner didn't cost very much. May cut it.

... or file down the cargo divider...

Sponsored

 

[someccie]

I didn't realize there were bed liners available. Kind of torn if I want one.

I have the vault divider which I like to use. Makes it super easy to stop things from moving around. I throw a clamp on it to stop things from moving laterally or even a strap.

Sorry, by bed liner, I meant the stock piece of plastic-like material bolted down covering the air suspension tank, battery connections, and so forth that sit under the bed.

 

[HellsNels]

It's a dumb design. The V2 should have more relaxed tolerances (i.e. higher clearance on the floor and bottom corners) to be more compatible with liners etc. and be easier to set into the rails agnostic of floor misalignments.

 

[Sxksxk]

The rear deck of my bed sits slightly higher than the section near the tail gate so I can’t latch either side unless it’s above the gear locker

I'm having the same issue. Any advice?

 

[NormalSpeed]

I'm having the same issue. Any advice?

Get one side in place then place all of your weight on other side. Thats what I had to do. They made the rubber feet too thick. There is no good reason for that.

 

[Sxksxk]

Get one side in place then place all of your weight on other side. Thats what I had to do. They made the rubber feet too thick. There is no good reason for that.

Won't work. The rubber feet hover like a 1-2mm above the floor. The divider metal bottom on the bed ridges.

 

[NormalSpeed]

Won't work. The rubber feet hover like a 1-2mm above the floor. The divider metal bottom on the bed ridges.

Well that is messed up.

 

[Cyber_P]

Someone has a printables mod for the inserts. I couldn't fit it in aoat.anywhere. Now if I lock one side after installing the spacers on the high side I can fit the divider in. Withoderate difficulty. But it's snug!!

 

[Sxksxk]

Someone has a printables mod for the inserts. I couldn't fit it in aoat.anywhere. Now if I lock one side after installing the spacers on the high side I can fit the divider in. Withoderate difficulty. But it's snug!!

The main problem is I can't get it to go into the L track when it's in the middle of the bed.

 

[Cyber]

I can’t get mine in the L track at the middle of the bed either. This thing is $300 of hot garbage.

 

[Guylouis]

The front deck is warped / improperly installed.

You will notice that the vault divider fits perfectly above the gear locker but not anywhere else

Tesla either needs to redesign the vault divider or the plastic lid for the air compressor tank

 

[Cyber]

Correct. I am hopeful they will make things right.

 

[Sxksxk]

I can’t get mine in the L track at the middle of the bed either. This thing is $300 of hot garbage.

I think it's because the main plate of the bed isn't even. It's slanted up and isn't supposed to be.

 

[jameskk]

Cut it.

Believe it or not, I installed mine without any modifications to the bed cover. I anticipated having to cut it but I simply pushed it down hard and locked it in place first time I tried.

Here is a video I made of some accessories with photos of it installed:

 

[NormalSpeed]

Nice! No way would mine lock in. A good way to make this product better is to not rivet the rubber feet and provide different depths to accommodate

Sponsored